14 – Command Reference
Set Setup Radius
14-114 59183-03 A
S
The following is an example of the Set Setup Radius Server command:
SANbox (admin) #> set setup radius server 1
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the attributes
for the server being processed, press 'q' or 'Q' and the ENTER key to do so.
If you wish to terminate the configuration process completely, press 'qq' or
'QQ' and the ENTER key to so do.
PLEASE NOTE:
-----------
* SSL must be enabled in order to configure RADIUS User Authentication
SSL can be enabled using the 'set setup services' command.
Server 1 Current Values:
ServerIPAddress 10.20.11.8
ServerUDPPort 1812
DeviceAuthServer True
UserAuthServer True
AccountingServer False
Timeout 10
Retries 0
SignPackets False
Secret **********
New Server 1 Value (press ENTER to accept current value, 'q' to skip):
ServerIPAddress (hostname, IPv4, or IPv6 address) :
ServerUDPPort (decimal value) :
DeviceAuthServer (True / False) :
UserAuthServer (True / False) :
AccountingServer (True / False) :
Timeout (decimal value, 10-30 secs) :
Retries (decimal value, 1-3, 0=None) :
SignPackets (True / False) :
Secret (1-63 characters, recommend 22+) :
Do you want to save and activate this radius setup? (y/n): [n]
To Next Page
Loading...
Need help?
General
