Qlogic SANbox 5600 Series

14 – Command Reference
Security
59183-03 A 14-77
A
Security
Opens a Security Edit session in which to manage the security database on a
switch. Refer to the “Group” command on page 14-29 and the “Securityset”
command on page 14-81.
Authority Admin session. The keywords Active, History, Limits, and List are available
without an Admin session.
Syntax security
active
cancel
clear
edit
history
limits
list
restore
save
Keywords active
Displays the active security set, its groups, and group members. This keyword
does not require an Admin session.
cancel
Closes a Security Edit session without saving changes. Use the Edit keyword to
open a Security Edit session.
clear
Clears all inactive security sets from the volatile edit copy of the security
database. This keyword does not affect the non-volatile security database.
However, if you enter the Security Clear command followed by the Security Save
command, the non-volatile security database will be cleared from the switch.
NOTE:
This command requires the Fabric Security license key. To purchase a
license key, contact your authorized maintenance provider or authorized
reseller. Use the Feature command to install a license key.
NOTE:
The preferred method for clearing the security database from the switch is
the Reset Security command.