Qlogic SANbox 5600 Series

14 – Command Reference
Show Mem
59183-03 A 14-157
A
Show Mem
Displays information about memory activity.
Authority None
Syntax show mem [count]
Keywords [count]
The number of seconds for which to display memory information. If you omit
[count], the value 1 is used. Displayed memory values are in 1K block units.
Examples The following is an example of the Show Mem command:
SANbox #> show mem
procs -----------memory---------- ---swap-- -----io---- --system-- ----cpu----
r b swpd free buff cache si so bi bo in cs us sy id wa
1 0 0 334464 55932 18728 0 0 1 0 401 57 1 2 97 0
Filesystem space in use: 41138/53188 KB (77%)
NOTE:
This keyword will display memory activity updates until [count] is reached–it
cannot be interrupted. Therefore, avoid using large values for [count].