14 – Command Reference
Set Port
14-106 59183-03 A
S
Set Port
Sets port state and speed for the specified port temporarily until the next switch
reset or new configuration activation. This command also clears port counters.
Authority Admin session
Syntax set port clear
or
set port [port_number]
clear
speed [transmission_speed]
state [state]
Keywords [port_number]
Specifies the port. Ports are numbered beginning with 0.
clear
Clears the counters on all ports or the port given by [port_number].
speed [transmission_speed]
Specifies the transmission speed for the specified port. Choose one of the
following port speed values:
1Gb/s
One gigabit per second.
2Gb/s
Two gigabits per second.
4Gb/s
Four gigabits per second.
10Gb/s
Ten gigabits per second. This applies only to ports 16–19.
Auto
The port speed is automatically detected.
state [state]
Specifies one of the following administrative states for the specified port:
Online
Activates and prepares the port to send data.
To Next Page
Loading...
Need help?
General
