Qlogic SANbox 5600 Series - Filtering the Event Log Display

11 – Event Log Configuration
Displaying the Event Log
59183-03 A 11-3
A
The following is an example of the Show Log command:
SANbox #> show log
[327][day month date time year][I][Eport Port:0/8][Eport State=
E_A0_GET_DOMAIN_ID]
[328][day month date time year][I][Eport Port: 0/8][FSPF PortUp state=0]
[329][day month date time year][I][Eport Port: 0/8][Sending init hello]
[330][day month date time year][I][Eport Port: 0/8][Processing EFP, oxid= 0x8]
[331][day month date time year][I][Eport Port: 0/8][Eport State = E_A2_IDLE]
[332][day month date time year][I][Eport Port: 0/8][EFP,WWN= 0x100000c0dd00b845,
len= 0x30]
[333][day month date time year][I][Eport Port: 0/8][Sending LSU oxid=0xc:type=1]
[334][day month date time year][I][Eport Port: 0/8][Send Zone Merge Request]
[335][day month date time year][I][Eport Port: 0/8][LSDB Xchg timer set]
You can also filter the event log display with the Show Log Display command and
customize the messages that display automatically in the output stream.
 Filtering the Event Log Display
 Controlling Messages in the Output Stream
Filtering the Event Log Display
You can customize what events are displayed according to the component or
severity level. Enter the Show Log Display command to filter the events in the
display. You can choose from the following severity levels and component events:
 Informative events
 Warning events
 Critical events
 E_Port events
 Management server events
 Name server events
 Port events
 Switch management events
 Simple Network Management Protocol (SNMP) events
 Zoning events
The following example filters the event log display for critical events.
SANbox #> show log display critical