Qlogic SANbox 5600 Series Interface Manual

14 – Command Reference
Show Config Threshold
14-142 59183-03 A
S
Show Config Threshold
Displays alarm threshold parameters for the switch.
Authority None
Syntax show config threshold
Examples The following is an example of the Show Config Threshold command:
SANbox #> show config threshold
Configuration Name: default
------------
Threshold Configuration Information
-----------------------------------
ThresholdMonitoringEnabled False
CRCErrorsMonitoringEnabled True
RisingTrigger 25
FallingTrigger 1
SampleWindow 10
DecodeErrorsMonitoringEnabled True
RisingTrigger 25
FallingTrigger 0
SampleWindow 10
ISLMonitoringEnabled True
RisingTrigger 2
FallingTrigger 0
SampleWindow 10
LoginMonitoringEnabled True
RisingTrigger 5
FallingTrigger 1
SampleWindow 10
LogoutMonitoringEnabled True
RisingTrigger 5
FallingTrigger 1
SampleWindow 10
LOSMonitoringEnabled True
RisingTrigger 100
FallingTrigger 5
SampleWindow 10

Qlogic SANbox 5600 Series Specifications

General

Model	SANbox 5600 Series
Form Factor	1U
Switch Type	Fibre Channel
Supported Protocols	Fibre Channel
Management Interface	Web-based GUI, CLI, SNMP
Port Speed	1 Gbps, 2 Gbps
Fabric Type	Fibre Channel
Hot Swappable	Yes
Redundancy	Dual power supplies, hot-swappable
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	10% to 90% non-condensing