14 – Command Reference
Fcping
14-22 59183-03 A
S
Fcping
Verifies a Fibre Channel connection with another switch or a device and reports
status.
Authority None
Syntax fcping destination [address]
count [number]
timeout [seconds]
Keywords [address]
The address of the port or device with which to verify the Fibre Channel
connection. [address] can have one of the following formats:
6-character hexadecimal device Fibre Channel address (hex). Enter
addresses with or without the “0x” prefix.
16-character hexadecimal worldwide port name (WWPN) with the format
xx:xx:xx:xx:xx:xx:xx:xx or xxxxxxxxxxxxxxxx.
count [number]
Number of times given by [number] to repeat the command. If you omit this
keyword, the command is repeated once.
timeout [seconds]
Number of seconds given by [seconds] to wait for a response. If you omit this
keyword, the switch waits 1 second for a response.
Examples The following is an example of the Fcping command:
SANbox #> fcping 970400 count 3
28 bytes from local switch to 0x970400 time = 10 usec
28 bytes from local switch to 0x970400 time = 11 usec
28 bytes from local switch to 0x970400 time = 119 usec
NOTE:
This command requires the SANdoctor license key. To purchase a license
key, contact your authorized maintenance provider or authorized reseller.
Use the Feature command to install a license key.
To Next Page
Loading...
Need help?
General
