14 ā Command Reference
Show Interface
14-148 59183-03 A
S
Show Interface
Displays the status of the active network interfaces.
Authority None
Syntax show interface
Examples The following is an example of the Show Interface command:
SANbox #> show interface
eth0 Link encap:Ethernet HWaddr 00:C0:DD:00:00:27
inet addr:10.20.116.131 Bcast:10.20.116.255 Mask:255.255.255.0
inet6 addr: fd70:c154:c2df:116:2c0:ddff:fe00:27/64 Scope:Global
inet6 addr: fe80::2c0:ddff:fe00:27/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:137168 errors:0 dropped:0 overruns:0 frame:0
TX packets:2194 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:47764214 (45.5 Mb) TX bytes:328639 (320.9 Kb)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.255.255.255
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:3887 errors:0 dropped:0 overruns:0 frame:0
TX packets:3887 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:272461 (266.0 Kb) TX bytes:272461 (266.0 Kb)
To Next Page
Loading...
