14 – Command Reference
Set Setup Radius
59183-03 A 14-113
A
Examples The following is an example of the Set Setup Radius Common command:
SANbox (admin) #> set setup radius common
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the attributes
for the server being processed, press 'q' or 'Q' and the ENTER key to do so.
If you wish to terminate the configuration process completely, press 'qq' or
'QQ' and the ENTER key to so do.
PLEASE NOTE:
-----------
* SSL must be enabled in order to configure RADIUS User Authentication
SSL can be enabled using the 'set setup services' command.
Current Values:
DeviceAuthOrder Local
UserAuthOrder Local
TotalServers 1
New Value (press ENTER to not specify value, 'q' to quit):
DeviceAuthOrder 1=Local, 2=Radius, 3=RadiusLocal :
UserAuthOrder 1=Local, 2=Radius, 3=RadiusLocal :
TotalServers decimal value, 0-5 :
Do you want to save and activate this radius setup? (y/n): [n]
To Next Page
Loading...
Need help?
General
