Qlogic SANbox 5600 Series

14 – Command Reference
Set Setup Callhome
59183-03 A 14-109
A
Notes  The Callhome service must be active to support Call Home e-mail
notification. Refer to the “Set Setup Services” command on page 14-115.
 The primary, secondary, or both SMTP servers must be properly addressed
and enabled on the switch to activate Call Home e-mail notification. If both
SMTP servers are enabled, the primary server is active.
 The switch will reroute Call Home e-mail messages to the secondary SMTP
server if the primary should become unavailable. Primary and secondary
identities do not change upon transfer of control.
 Callhome profiles determine the events, conditions, and e-mail recipients of
Call Home e-mail messages. Refer to the “Profile” command on page 14-61
for information about creating Call Home profiles.
FromEmailAddress E-mail address that is defined as the sending
address in the From: field of the e-mail message.
The format is account@domain. This field is
required. Undeliverable messages are returned to
this address unless overridden by the
ReplayToEmailAddress parameter.
ReplyToEmailAddress E-mail address that is to receive replies to the out-
bound e-mail message. The format is
account@domain. This parameter overrides the
FromEmailAddress parameter.
ThrottleDupsEnabled Enables (True) or disables (False) the throttling of
duplicate e-mail messages in the message queue.
When enabled, duplicate e-mail messages that
enter the queue within 15 seconds of the original
are suppressed. The original message is sent with
a report of the number of suppressed duplicates.
Table 14-25. Call Home Service Configuration Settings
Entry Description