14 – Command Reference
Set Setup System
14-126 59183-03 A
S
Examples The following is an example of the Set Setup System Dns command:
SANbox (admin) #> set setup system dns
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
DNSClientEnabled False
DNSLocalHostname <undefined>
DNSServerDiscovery Static
DNSServer1Address <undefined>
DNSServer2Address <undefined>
DNSServer3Address <undefined>
DNSSearchListDiscovery Static
DNSSearchList1 <undefined>
DNSSearchList2 <undefined>
DNSSearchList3 <undefined>
DNSSearchList4 <undefined>
DNSSearchList5 <undefined>
New Value (press ENTER to accept current value, 'q' to quit, 'n' for none):
DNSClientEnabled (True / False) :
DNSLocalHostname (hostname) :
DNSServerDiscovery (1=Static, 2=Dhcp, 3=Dhcpv6) :
DNSServer1Address (IPv4, or IPv6 Address) :
DNSServer2Address (IPv4, or IPv6 Address) :
DNSServer3Address (IPv4, or IPv6 Address) :
DNSSearchListDiscovery (1=Static, 2=Dhcp, 3=Dhcpv6) :
DNSSearchList1 (domain name) :
DNSSearchList2 (domain name) :
DNSSearchList3 (domain name) :
DNSSearchList4 (domain name) :
DNSSearchList5 (domain name) :
Do you want to save and activate this system setup? (y/n): [n]
To Next Page
Loading...
Need help?
General
