Qlogic SANbox 5600 Series Interface Manual

6 – Port Configuration
Modifying Port Operating Characteristics
6-8 59183-03 A
S
You can configure all ports based a specified source port using the
Set Config Ports command. The following example configures ports 0–19 based
on port 3.
SANbox #> admin start
SANbox (admin) config edit
SANbox (admin) #> set config ports 3
.
.
.
SANbox (admin-config)#> config save
SANbox (admin)#> config activate
SANbox (admin)#> admin end
The following example temporarily changes the port 1 administrative state to
Down:
SANbox #> admin start
SANbox (admin) #> set port 1 state down

Qlogic SANbox 5600 Series Specifications

General

Model	SANbox 5600 Series
Form Factor	1U
Switch Type	Fibre Channel
Supported Protocols	Fibre Channel
Management Interface	Web-based GUI, CLI, SNMP
Port Speed	1 Gbps, 2 Gbps
Fabric Type	Fibre Channel
Hot Swappable	Yes
Redundancy	Dual power supplies, hot-swappable
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	10% to 90% non-condensing