Interface Page 81 of 81
Table 3-4: IEEE & RS-232 Commands (continued)
Command Function Parameter(s)
SEQuence:
TEST Set current step to test number nn NONE SKIP
CALC
CALCulate:
CMODe Set measurement mode to calculate AC ACRE ACIM
CHIGh Set High limit in mA nn.nnn
CLOW Set Low limit in mA nn.nnn
SYSTem:
When configuring any of these commands for remote operation it is
necessary to send a “STOP” command to implement the changes.
OFFSet Measure the Offset OFF ON GET
SHOW Show Test Locations HIDE ALL
BUZZer Turn on buzzer on failure LOUD SOFT OFF
BEEP Beep when a key is pressed OFF ON
ENHanced Show enhanced features on display OFF ON
LOWLimit Low Limit is tested continuous or EOT LCONtinuous EOT
TDElay Set the delay time nnn.n OFF
CVOF Continuous voltage on fail OFF ON
CSOF Continue on Fail to Next Step OFF ON
STP Stop Test on Pass OFF ON
SAI Step and Increment OFF ON
CLR Clear all tests YES
VTEsts Tests to View VALL
VSINgle VSEQuence
GFS Ground Fault Stop OFF ON OFFGnd
(DUT grounded)
ARCWidth Arc Pulse Width in µs nn
VADJust Adaptive DC Ramp OFF ON
AUTOrange Autoranging 0 (None) 1 (Full)
2 (Limited)
LOCKout Lockout the keypad from the remote OFF ON
To Next Page
Loading...
