ppbRAE 3000 User’s Guide
102
Determining The Lamp Type
The monitor can accommodate two lamp values: 10.6eV (standard)
and 9.8eV.
There are two ways to determine the lamp type.
1. Turn off the instrument and remove the lamp. Now look at
the serial number. The following identify the lamp type:
10.6eV SN: 106 2Nxxxxx
9.8eV SN: 098 2Nxxxxx
2. When the monitor is running, the lamp type is shown along
with the calibration and measurement gas and Correction
Factor:
Note: This screen can be accessed from the reading screen by
pressing [N/-] four times.
Programming The Lamp ID
The correct measurement gas library is used by the instrument when
you ensure that the right lamp value is programmed.
To manually select the Lamp ID:
1. Enter the Programming menu.
2. Select Monitor Setup.
3. Scroll down and select the Lamp ID sub-menu.
4. Press [N/-] to scroll down to the desired Lamp ID.
5. Press [Y/+] to select.
6. Press [MODE] to select Done.
7. Select “Save.”
8. Return to the main menu.
Recalibrate the instrument before returning it to service.
To Next Page
Loading...
Need help?
General
