Rae ppbRAE 3000 User Manual

ppbRAE 3000 User’s Guide
67
1. Scroll through the Datalog sub-menu using the [N/-] key until the
display shows the desired parameter to be changed:
Clear Datalog
Interval
Data Selection
Datalog Type
2. Press [Y/+] to make your selection. Exit by pressing [MODE] for
Back.
Clear Datalog
This erases all the data stored in the datalog.
Note: Once the datalog is cleared, the data cannot be recovered.
Press [Y/+] to clear the datalog. The display asks, “Are you sure?”
 Press [Y/+] if you want to clear the datalog. When it has been
cleared, the display shows “Datalog Cleared!”
 Press [N/-] if you do not want to clear the datalog.
The display changes, and you are taken to the next sub-menu,
Interval.
Interval
Intervals are shown in seconds. The default value is 60 seconds. The
maximum interval is 3600 seconds.
1. Press [Y/+] to increase each digit’s value.
2. Press [N/-] to advance to the next digit.
3. Again, use [Y/+] to increase the number.

Rae ppbRAE 3000 Specifications

General

Brand	Rae
Model	ppbRAE 3000
Category	Measuring Instruments
Language	English