ppbRAE 3000 User’s Guide
53
Programming Mode
Programming Mode can be entered from either Hygiene Mode or
Search Mode. If the current user mode is Basic, you must provide a 4-
digit password to enter.
Entering Programming Mode
1. Press and hold [MODE] and [N/-] until you see the Password
screen.
2. Input the 4-digit password:
Increase the number from 0 through 9 by pressing [Y/+].
Step from digit to digit using [N/-].
Press [MODE] when you are done.
If you make a mistake, you can cycle through the digits by pressing
[N/-] and then using [Y/+] to change the number in each position.
Note: The default password is 0000.
When you have successfully entered Programming Mode, you see
this screen:
To Next Page
Loading...
