ppbRAE 3000 User’s Guide
96
Uploading Firmware To The instrument From
A PC
Uploading new firmware to your instrument requires connecting the
instrument and PC. Follow these steps to make the connection:
1. Connect the data cable to the PC and the cradle.
2. Place the instrument into its cradle. The charging LED should
be illuminated.
3. Start RAEProgrammer 7000 on your PC.
4. From RAEProgrammer 7000, select “Operation” and select
Setup Connection.
5. Select the COM port to establish a communication link
between the PC and the instrument.
6. Select Operation Download Firmware.
Once communication is established, follow the instructions that
accompany RAEProgrammer 7000 and the firmware to upload the
new firmware to your instrument.
Note: Check for the latest updates to ProRAEProgrammer 7000 at
www.raesystems.com.
To Next Page
Loading...
Need help?
General
