Calibration regulator and Flow controller
Standard Kit & Accessories
AC Adapter (Battery Charger)
WARNING
To reduce the risk of ignition of hazardous atmospheres, recharge
battery only in area known to be non-hazardous. Remove and
replace battery only in area known to be non-hazardous.
Ne charger les batteries que dans emplacements designés non-
dangereuses.
A battery charging circuit is built into the instrument cradle. It only needs a
regular AC to 12 VDC adapter (wall-mount transformer, part number 500-
0114-000) to charge the instrument.
To charge the battery inside the instrument:
1. Power off the instrument.
2. Connect the AC adapter to the DC jack on the instrument’s cradle.
If the instrument is off, it automatically turns on.
3. While charging, the display message shows “Charging.” The
Primary LED on the cradle flashes green when charging.
4. When the battery is fully charged, the LED changes to glowing
green continuously, and the message “Fully charged” appears on