ppbRAE 3000 User’s Guide
54
Note: The password can only be changed by connecting the
instrument to a PC running ProRAE Studio software. Follow the
instructions in ProRAE Studio to change it.The Calibration label is
shown and its icon is highlighted, but you can press [N/-] to step from
one programming menu to the next, with the name of the menu shown
at the top of the display and the corresponding icon highlighted. As
you repeatedly press [N/-], the selection moves from left to right, and
you see these screens:
Note: When you reach Monitor Setup and press [N/-], the menu
cycles back to Calibration.
Programming Mode Menus
The Programming Mode allows anyone with the password to change
the instrument’s settings, calibrate the instrument, modify the sensor
configuration, enter user information, etc. Programming Mode has
five menus. Each menu includes several sub-menus to perform
additional programming functions.
The table on the next shows the menus and sub-menus.
To Next Page
Loading...
Need help?
General
