ppbRAE 3000 User’s Guide
72
The current mode is indicated by a dark circle within the circle in
front of either Hygiene or Search.
1. Select Hygiene or Search by pressing [N/-]. The highlighting
changes from one to the other each time you press [N/-].
2. Press [Y/+] to select that mode for the instrument.
3. Press [MODE] when you want to register your selection to
place the instrument in the selected mode.
4. Press [Y/+] to commit the change and exit to the Monitor
Setup screen, or press [N/-] to Undo (exit to the Monitor
Setup screen without changing the Mode).
Site ID
Enter an 8-digit alphanumeric/character Site ID in the programming
mode. This Site ID is included in the datalog report.
1. Press [Y/+] and the display shows the current site ID.
Example: “RAE00001.” Note that the left-most digit flashes
to indicate it is the selected one.
2. Press [Y/+] to step through all 26 letters (A to Z) and 10
numerals (0 to 9).
Note: The last four digits must be numerals.
3. Press [N/-] to advance to the next digit. The next digit to the
right flashes.
Repeat this process until all eight digits of the new site ID are
entered.
Press [MODE] to exit.
If there is any change to the existing site ID, the display shows
“Save?” Press [Y/+] to accept the new site ID. Press [N/-] to discard
the change and move to the next sub-menu.
To Next Page
Loading...
Need help?
General
