Rae ppbRAE 3000 User Manual

ppbRAE 3000 User’s Guide
81
Lamp ID
The ppbRAE 3000 does not automatically identify the type of lamp,
so you must select a lamp type manually.
1. Scroll through the menu by pressing [N/-].
2. Press [Y/+] to make a selection.
3. Press [MODE] when you are done.
4. Press [Y/+] to save your choice or [N/-] to undo your selection.
PAN ID
The ppbRAE 3000 and any other devices that you want to
interconnect wirelessly must have the same PAN ID. You can set the
PAN ID in the instrument or through ProRAE Studio II.
1. Press [N/-] to advance through the digits from left to right.
2. Press [Y/+] to ] to advance through the numbers (1, 2, 3, etc.).
3. Press [MODE] to register your choice when you are done.
Mesh Channel
Note: For mesh radio modems operating at 868MHz, only channel 0
is available. For other frequencies, channels 1 through 10 are allowed.
1. Press [Y/+] to increase the number and [N/-] to advance to
the next digit.
2. After moving to the last digit and making changes, press
[MODE].
 Press [Y/+] to save the change.
 Press [N/-] to undo the change.
Mesh Interval
Set the time interval at which the instrument’s mesh radio sends out a
signal. This can range from once every 10 seconds to once every four

Rae ppbRAE 3000 Specifications

General

Brand	Rae
Model	ppbRAE 3000
Category	Measuring Instruments
Language	English