ppbRAE 3000 User’s Guide
73
User ID
Enter an 8-digit alphanumeric User ID in the programming mode.
This User ID is included in the datalog report.
1. Press [Y/+] and the display shows the current User ID.
Example: “RAE00001.” Note that the left-most digit flashes
to indicate it is the selected one.
2. Press [Y/+] to step through all 26 letters (A to Z) and 10
numerals (0 to 9).
3. Press [N/-] to advance to the next digit. The next digit to the
right flashes.
Repeat this process until all eight digits of the new User ID
are entered.
Press [MODE] to exit.
If there is any change to the existing User ID, the display shows
“Save” Press [Y/+] to accept the new site ID. Press [N/-] to discard
(undo) the change and move to the next sub-menu.
To Next Page
Loading...
