ppbRAE 3000 User’s Guide
71
Snapshot Datalog
When the instrument is in Snapshot datalogging mode, it captures a
single “snapshot” of the data at the moment of your choosing.
Whenever the instrument is on and it is set to Snapshot, all you have
to do is press [MODE] each time you want to capture a snapshot of
the data at that instant.
When you send the data to a computer using ProRAE Studio, the data
snapshots are uniquely identified by time and other parameters.
Monitor Setup
Many settings can be accessed in this menu, including setting the date
and time and adjusting the pump’s on/off duty cycle.
Op Mode
Under Monitor Setup is “Op Mode.”
Press [Y/+] to select.
You see two options (one is highlighted):
Hygiene
Search
To Next Page
Loading...
