ppbRAE 3000 User’s Guide
56
Once you enter Programming Mode, the LCD displays the first menu,
Calibration. Each subsequent menu is accessed by pressing [N/-]
repeatedly until the desired menu is displayed. To enter a sub-menu
of a menu, press [Y/+].
Exiting Programming Mode
To exit Programming Mode and return to normal operation, press
[MODE] once at any of the programming menu displays. You will
see “Updating Settings…” as changes are registered and the mode
changes.
Navigating Programming Mode Menus
Navigating through the Programming Mode menus is easy and
consistent, using a single interface format of “Select,” “Back” and
“Next” at the top level. The three control buttons correspond to these
choices as shown:
Note: Pressing [MODE] in the Programming Mode’s top level causes
the instrument to exit Programming Mode and return to monitoring.
To Next Page
Loading...
Need help?
General
