R&S EB200 - Page 166

EB200 Manual SENSe subsystem SWEep
4052.2000.02 4.92 E-7
. . . :TIME? [MINimum|MAXimum]
Query of hold time during signal-controlled scan continuation
Parameters:
none query of current hold time
MINimum|MAXimum query of lowest|highest hold time
Result:
Hold time in seconds
Example:
SWEep:HOLD:TIME? 0.010
. . :STEP<numeric_value>|MINimum|MAXimum
Setting the frequency stepwidth for the frequency scan
Parameters:
<numeric_value> frequency value
MINimum|MAXimum setting the smallest/biggest frequency stepwidth
*RST state:
10 kHz
Example:
SWEep:STEP 25 kHz
. . :STEP? [MINimum|MAXimum]
Query of frequency stepwidth of a frequency scan
Parameters:
none query of current frequency stepwidth
MINimum|MAXimum query of smallest|largest frequency stepwidth
Result:
Stepwidth in Hz
Example:
SWEep:STEP? -> 25000