Since the metering rollers are often seated very
tightly
in the bracket, it is possible to insert a
mounting lever or a shaft into the metering roller
and use it to pry it out for easier removal.
Replacing the cam wheels
u
Remove the bush.
u
Pull of
f the Nilos ring.
u
Pull off the bearing [1].
u
Next, remove the first circlip [3].
u
Remove the stop of the metering tank [2].
u
Now only the second shaft circlip [3] must
be removed.
u
Remove the cam wheels.
10.6 Checking and adjusting extended boom
The boom segments are preset at the factory to the correct position and the correct holding force.
They
only have to be readjusted after individual parts of the boom operating device and individual
boom segments have been replaced.
Please contact our Service department before starting with the adjustment.
• The
boom segments must form one line both in the vertical as well as in the horizontal
orientation after the individual segments have been folded out.
• At the same time, the sealing funnels must make close contact with the joint bearings of the boom
elements.
10. Maintenance and service
100
5903494 AERO GT 60.1
To Next Page
Loading...
