3.11 Warning and instruction stickers
Various warning and instruction stickers are attached to the machine (for the position at the machine,
please refer to 3.10.1 Position of safety equipment as well as warning and instruction stickers).
The
warning and instruction stickers are components of the machine. They must not be removed or
modified.
u
Replace missing or illegible warning and instruction stickers immediately
.
If new components are installed during repairs, the same warning and instruction stickers that were on
the original parts must be placed on the new parts.
The correct warning and instruction stickers can be obtained from the spare parts service.
3.11.1 Warning stickers
Illustration Description
Read the operator's manual and warnings.
Read and observe the operator
’s manual and warnings before
commissioning the machine. The operator’s manual explains in detail
how to operate the spreader and contains valuable information on
operation, care and maintenance.
Remove the ignition key.
Switch of
f the engine and remove the key before carrying out
maintenance and repair work. Disconnect the power supply
Crushing hazard
Risk of crushing a hand. It is prohibited to reach into the hazard zone.
Danger due to ejection of material
Danger of injury to the whole body caused by ejected spreading
material
Before commissioning, instruct all people to leave the hazard zone
(spreading range) of the machine.
3. Safety
AERO GT 60.1 5903494
23
To Next Page
Loading...
