8 Spreading operation
8.1 General information
Please note that the service life of the machine mainly depends on your driving behavior.
u
Pay close attention to the machine settings. Even a slightly incorrect setting may adversely affect
the spreading pattern.
u
Check that your machine is working properly and that the application is sufficiently precise before
every use of the spreader and during work (carry out a calibration test).
u
Reduce the speed on uneven ground.
u
Prevent the boom from hitting the ground.
u
Special care is to be particularly taken when driving on uneven, soft ground (e.g., when entering
fields, curbs).
u
Drive with care through the headlands.
u
Avoid sudden and rapid turns when driving uphill or downhill or across a slope.
w
The change in the center of gravity may increase the danger of tipping.
• The
machine's operation depends on the driving speed. When the driving speed changes, the
metering shaft speed is adjusted automatically.
• The control pump maintains the blower rpm at universal drive shaft speeds of 700 to 1000 rpm. In
this range, you do not have to pay attention to maintaining the universal drive shaft speed while
driving.
Claims for damage other than to the machine will not be accepted.
This also means that no liability will be accepted for damage resulting from spreading errors.
8.2 Instructions regarding the spreading operation
The modern technology and design of our machines and exhaustive, continuous testing in the
factory's fertilizer spreader test system ensure that you will have a perfect spreading pattern.
In
spite of the care taken during machine manufacture, deviations in fertilizer application or other faults
are possible even with designated usage.
8. Spreading operation
70
5903494 AERO GT 60.1
To Next Page
Loading...
