u
Remove the dirt deflector (refer to 4.2.1 Assembly overview).
u
Fold up the protective grid in the hopper (refer to 4.2.1 Assembly overview).
u
When
cleaning with high-pressure, never aim the water jet directly at warning signs, electrical
equipment, hydraulic components, and sliding bearings.
u
Let the machine dry after cleaning.
Do not store the terminal outdoors. Store in a suitable warm location.
Lubricating the machine before winterization (refer to 10.14 Lubrication)
11.3 Preserving the machine
• Only spray on approved and environmentally friendly preserving agents.
• Prevent
mineral oil-based agents (diesel, etc.). They are rinsed off when the machine is first
washed and can get into the sewage system.
• Only use preservation agents that will not attack the paint, plastics, and rubber seals.
u
Only spray the machine once certain that it is completely clean and dry.
u
T
reat the machine with environmentally friendly anti-corrosion agents.
w
We recommend using protective wax or preservation wax.
Please contact your specialist dealer or your specialist workshop if you want to obtain preservation
agents.
Preserve the following assemblies or parts:
• All
hydraulic components that are susceptible to rust, e.g., hydraulic couplers, pipes, press-fit
rings, and valves
• Galvanized bolts
• If present on your machine:
○ Parts of the braking system
○ Pneumatic lines
○ Spray galvanized bolts on the axles and the drawbar with a special protective wax after
washing.
11. Winterization and preservation
136
5903494 AERO GT 60.1
To Next Page
Loading...
