u
Press the Lower boom
function key for at least 5 seconds:
The boom rests on the supports on the side of the hopper.
The transport locks are closed.
8.8 Discharging residual material
To protect against corrosion and blockages as well as to maintain the properties of the fertilizer, we
recommend
that you discharge the residual material on a daily basis after use. You can reuse the
fertilizer afterwards.
DANGER!
Danger of injury due to running engine
W
orking on the machine with the engine running may result in serious injury caused by mechanical
components and escaping fertilizer.
u
Never carry out the operations for discharging the residual quantity while the motor/drive
shaft is switched on.
u
Switch off the tractor engine.
u
Remove the ignition key.
u
Ensure that nobody is present in the hazard zone.
Requirements:
•
The machine is parked on even and solid ground and secured against tilting and rolling.
• During discharge of residual material, the machine is coupled to the tractor.
u
Expose the front air duct and lower it down (refer to chapter 7.1 Disconnecting the metering unit).
u
Carefully
remove the front air duct and set
it aside.
Fig. 47: Removing the air duct
8. Spreading operation
80
5903494 AERO GT 60.1
To Next Page
Loading...
