Rauch AERO GT 60.1 - Preparing the Machine for Driving; Disengaging the Parking Brake; Switching on the Hydraulic System

8.3 Preparing the machine for driving
Requirements:
•
The machine is securely coupled to the tractor. See 6.7.2 Mounting
• The support stand is folded away. See Chapter 6.7.2.3 - Folding away the support stand -
Page 53
• The stairs are folded up and secured. See Folding in the steps in transport position 60
8.3.1 Disengaging the parking brake
Only disengage the parking brake [1] after the machine is coupled to the tractor and the pneumatic
lines are connected.
u
Remove the wheel chocks and insert them into the transport bracket.
u
Press the button [1].
w
The parking brake is disengaged.
Fig. 43: Disengaging the parking brake
[1] Parking brake [2] Operating brake
8.3.2 Switching on the hydraulic system
n
Switching on the hydraulic system
u
T
o switch on the ISOBUS terminal in the tractor's cabin, refer to 6.14 Switching on the machine
control unit.
u
Switch on the hydraulic valve on the tractor for the boom-type mineral fertilizer spreader.
The hydraulic valve for the boom-type mineral fertilizer spreader must also be switched when
driving on roads.
8. Spreading operation
72
5903494 AERO GT 60.1