7 Calibration
For precise control of the discharge amount, we recommend running a new calibration test every time
the fertilizer material type is changed.
Execute the calibration:
• Before spreading for the first time
•
If the fertilizer quality has changed significantly (moisture, high dust content, granulate damage)
• If a new fertilizer type is used
The calibration must be conducted while the motor is running at a standstill or during travel over a test
track.
If the section is reduced, the calibration test should not be used to calibrate the machine. The
application rate check can be performed even if the section is reduced.
Requirements:
•
The machine is attached to the tractor.
• The hydraulic, electric, and pneumatic lines are connected.
As described below, always perform the calibration test on the first metering on the left front in the
direction of travel. In the control unit, this corresponds to section no. 3 [1]. This section is the default
factory setting and can be changed manually if necessary.
Fig. 35: Illustration of the sections on the boom-type mineral fertilizer spreader
7. Calibration
AERO GT 60.1 5903494
63
To Next Page
Loading...
