Normal fertilizing
u
Insert
the baffle into the upper bracket
facing downward.
Fig. 46: Baffle in normal fertilizing mode
Late fertilizing
The
operating height on the baffles of the innermost bend must not be less than 0.7 m above the
existing plants during late fertilizing.
• Adjust the height of the boom to the existing plants. See Chapter 8.5 - Manual adjustment of
the boom - Page 75
8.6.2 Spreading with section control
You can adjust the working width when activating or deactivating the sections. These settings can be
configured
directly in the working screen. You can use these to optimally adapt them to the field
requirements during spreading operation.
Button Spreading type
Switching off the section from the left to the center
Activating the section from the center to the left
Switching off the section from the right to the center
8. Spreading operation
78
5903494 AERO GT 60.1
To Next Page
Loading...
