Rauch AERO GT 60.1 - Checking and Adjusting the Folded in Boom; Holding Force of the Boom Segments

Adjust the holding force of the boom central section to the start section on the disc spring assembly on
the 2nd hydraulic cylinder (folded out condition).
Boom central section to start section
u
Release the lock nut [1].
u
Adjust
dimension X by turning the threaded
rod [2] on the 2nd hydraulic cylinder.
w
Dimension X min. 60 mm
Fig. 61: Changing the holding tension on the 2nd
hydraulic cylinder
Adjust the holding force of the boom end section on the disc spring assembly on the 3rd hydraulic
cylinder (folded out condition).
Boom end section
u
Release the lock nut [1].
u
T
urn the threaded rod [2] on the 3rd
hydraulic cylinder.
w
Gap size of the disc spring min. 1 mm
Fig. 62: Changing holding tension on 2nd hydraulic
cylinder
10.8 Checking and adjusting the folded in boom
n
Holding force of the boom segments
10. Maintenance and service
104
5903494 AERO GT 60.1