Fig. 34: Rear view camera screenshot
6.14 Switching on the machine control unit
Requirements:
•
The machine control unit is correctly connected to the machine and the tractor.
○ For an example, see Chapter 6.7 Installing the machine at the tractor.
• The minimum voltage of 11 V is guaranteed.
Due to the great variety of different ISOBUS-compatible terminals, this chapter is limited to the
functions of the electronic machine control system without indicating a specific ISOBUS terminal.
• Please
observe the instructions for the operation of your ISOBUS terminal in the
corresponding operator's manual.
u
Start the machine control unit.
After a few seconds, the start-up screen of the machine control unit is displayed.
Subsequently
, the machine control unit displays the activation menu for a few seconds.
u
Press the enter key.
The working screen then appears.
You can find detailed information on how to use the machine in the operator’s manual
of the electronic machine control. unit
The
operator’s manual of the electronic machine control unit AERO ISOBUS is
included in the scope of supply.
• If it is no longer present, please contact your dealer or your specialist workshop.
6. Commissioning
62
5903494 AERO GT 60.1
To Next Page
Loading...
