10 Maintenance and service
10.1 Safety
Please note the warnings in the chapter 3 Safety
T
ake particular note of the instructions in the section. 3.8 Maintenance and service
Observe the following instructions in particular:
• W
elding and work on the electrical and hydraulic systems is to be carried out by qualified
technicians only.
• There is a risk of tipping when working at the lifted machine. Always secure the machine using
suitable supports.
• Always use both eyelets in the hopper for lifting the machine by means of hoisting gear.
• There is a risk of crushing and shearing at power-operated components. Make sure that there is
no one in close proximity to the moving parts during maintenance.
• Spare parts must at least comply with the technical standards specified by the manufacturer. This
is assured with original spare parts.
• Before starting any cleaning, maintenance, or repair work, and when troubleshooting, switch off
the tractor's engine and wait until all moving parts of the machine have come to a stop.
• By controlling the machine with an operating unit, additional risks and hazards due to externally
operated components may arise.
○ Disconnect the power supply between the tractor and the machine.
○ Disconnect the power supply cable from the battery.
• Repairs may ONLY be carried out by instructed and authorized workshops.
DANGER!
Danger of injury due to running engine
W
orking on the machine with the engine running may result in serious injury caused by mechanical
components and escaping fertilizer.
u
Wait until all moving parts have come to a complete stop before making any adjustments or
performing maintenance work.
u
Switch off the tractor engine.
u
Remove the ignition key.
u
Ensure that nobody is present in the hazard zone.
n
Maintenance plan
10. Maintenance and service
92
5903494 AERO GT 60.1
To Next Page
Loading...
