Rauch AERO GT 60.1 - Page 102

u
Check
which boom segment is not oriented
correctly.
u
Release the lock nut [1] on the stop screw
to be adjusted.
u
Adjust the stop screws [2] at the respective
link points.
Distance A should be approx. 47 mm in
each case at the top, in the middle, and at
the bottom.
w
The boom segments must form one
vertical line.
w
The sealing funnels must make close
contact.
w
Distance A should be approx. 47 mm
in each case at the top, in the middle,
and at the bottom.
u
Tighten the lock nut again.
Fig. 59: Adjusting folded-out boom segments
vertically
n
Boom segments: Horizontal orientation
Check
•
The boom segments form one line in the horizontal orientation.
• The sealing funnels are making close contact with the joint bearings of the boom elements.
10. Maintenance and service
102
5903494 AERO GT 60.1