Rauch AXIS EMC ISOBUS - Page 32

Fig. 12: Fertiliser settings menu, tab 3 and 4
Sub-menu Meaning Description
Fertiliser name Fertilizer selected from the fertilizer
chart
4.4.12 Fertilizer charts
Appl. rate (kg/ha) Input of target value for the application
rate in kg/ha
4.4.1 Application rate
Working width (m) Determination of the working width to
be spread
4.4.2 Set the working width
Flow factor Input of flow factor of the fertilizer used 4.4.3 Flow factor
Drop point Input of the drop point
For AXIS with electrical drop point
actuators: Drop point adjustment
Please observe the operator's
manual for the machine.
4.4.4 Drop point
Start calibration Accessing the sub-menu for executing
the calibration
4.4.5 Calibration
Normal disc speed AXIS-H
Input of the desired spreading disc
speed
Influences the EMC mass flow control
4.4.7 RPM
PTO AXIS-M
Influences the EMC mass flow control
Factory setting:
• AXIS-M 20.2/30.2: 540 rpm
• AXIS-M 50.2: 750 rpm
4.4.7 RPM
4. Operation
32
5902180-h-gb- AXIS EMC ISOBUS