Fig. 49: Distance off (measured from field border)
[B] Turn off distance [C] Field border
If you want to change the switch-off position, you need to adjust the Turn off dist. (m) accordingly.
• A lower value means that the switch-off position is closer to the field border.
• A greater value means that the switch-off position is closer to the center of the field.
If you want to turn through the headland track, enter a greater distance in Turn off dist. (m). Here, the
adjustment must be as low as possible so that the metering sliders close as soon as the tractor enters
the headland track. An adjustment of the switch-off distance may lead to insufficient fertilization around
the switch-off positions in the field.
5. Spreading operation
AXIS EMC ISOBUS 5902180-h-gb-
93
To Next Page
Loading...
