Fig. 48: Distance on (measured from field border)
[A] Turn on distance [C] Field border
If you want to change the switch-on position in the field, you need to adjust the Turn on dist. (m) value.
• A lower value for this distance means that the switch-on position is closer to the field border.
• A greater value means that the switch-on position is closer to the center of the field.
Turn off distance (m)
The Turn off dist. (m) parameter refers to the turn off distance [B] measured from the field border [C].
At this position in the field, the metering sliders start to close.
5. Spreading operation
92
5902180-h-gb- AXIS EMC ISOBUS
To Next Page
Loading...
