Rauch AXIS EMC ISOBUS - Page 97

No. Message in display Meaning and possible cause
52 Error at hopper cover The position of the hopper cover could not
be reached.
• Blockage
• Defective actuator
53 Defect at hopper cover The hopper cover actuator cannot reach the
target value for the movement.
• Blockage
• Defective actuator
57 Error at hopper cover The hopper cover actuator cannot reach the
target value for the movement.
• Blockage
• No position feedback
71 Impossible to reachdisc speed The spreading disc speed is not within the 5 %
target range.
• Problem with oil supply
• Proportional valve spring is jammed.
72 Error at SpreadLight Power supply is too high; the operating lights
will be switched off.
73 Error at SpreadLight Overload
74 Defect at SpreadLight Connection error
• Defective cable
• Loose plug connector
82 Type of machine modified.Spreading error
possible.New configuration required!
The operating modes cannot be combined with
certain machine types
u
Restart the machine control unit when
changing machine type.
u
Implement machine settings.
u
Load fertilizer chart for the machine type.
88 Error at disc speed sensor The spreading disc RPM could not be
determined
• Cable breakage
• Defective sensor
6. Alarm messages and possible causes
AXIS EMC ISOBUS 5902180-h-gb-
97