Raven ISOBUS Product Control - Page 83

Index
Manual No. 016-0171-362 Rev. F 75
C
Calibration 15
Calibration Screen 16
Alarms Setup Tab 34
Bin Level Sensor 35
Dual Encoder Error Percent 35
Low Limit 34
Low Tank 34
Off Rate Percent 35
RPM Off Rate Percent 35
Implement Calibration
Applicator Type 17
Section Setup 18
Total Width Display 17
Implement Calibration Tab 17
Product Control Calibration Tab 19
Control Type 20
Feature Settings 31
Meter Cal or Spreader Constant 20
Pulse Width Modulation Valves 27
Self Test Speed 21
Spinner/Fan Control Setup 24
Tank or Bin Capacity 21
Valve Cal 22
Valve Delay 21
Calibration Values
Calculating 61
Rate Cal 61
Section Widths 61
Spinner RPM 68
Spreader Constant 66
Valve Cal 64
E
Edit Mode vi
F
Flow Meter Maintenance and Adjustment
Procedure 71
H
Home Screen 37
Application Speed 39
Area Covered 44
Control Mode (Auto/Manual) 39
Pressure or Spinner/Fan RPM Display 41
Product Density (Granular Applications) 40
Rates Area 42
Remaining Tank/Bin Volume 43
Remote Master (Switch) Status 39
Section Status Display 45
Target Pressure (NH3 Applications) 40
Volume Applied 43
I
Important Safety Information 1
Electrical Safety 1
Installation 9
Cabling 13
Control Valve 10
Flow Meter 9
Mount the Foot Switch 13
Node 11
Introduction
Unit Definitions and Conversions vi
Unit of Measure Conversions vi
Unit of Measure Definitions vi
ISOBUS Product Control Node Kits 5
M
Manual Section Controls 45
O
Operation 37
P
Product Control Home Screen 37
S
System Diagrams 51
ISOBUS Granular Product Control System (22-pin
Product Cable) 56
ISOBUS Granular Product Control System (37-pin
Product Cable) 53
ISOBUS Liquid Product Control System (16-pin Product
Cable) 52
ISOBUS Liquid Product Control System (22-pin Product
Cable) 55
ISOBUS Liquid Product Control System (37-pin Product
Cable) 54
ISOBUS Trunk Line Cabling 51
T
Tally Registers 47
Area per Hour Display 48
Distance 48
Field Area and Volume 48
Total Area and Volume 48
Volume per Minute Display 48
Testing Extension Cables
Flow Meter Cables 71
U
Updates 6