23
Chapter 2: Getting Started and Controlling the Chart Display
Controlling
the Chart
D3821-1
REMOTE CENTER
SCROLL
DIGITS
SELECT
CLEAR
CANCEL
ENTER
ACCEPT
SELECTION
LAT: 39°21.11 N
LON: 009°52.55 E
Change the values to the screen centre, as follows:
a. Move the cursor to the first digit you wish to change, using the left or
right trackpad controls. When you move right from the latitude
direction, the cursor moves to the first longitude digit.
b. Increase or decrease the number, using the up or down trackpad
controls.
c. Repeat steps a and b until all the digits are set to the required values.
d. Press ENTER to set the position or CLEAR to cancel and return to the
initial display.
4. The display returns to the CENTER soft keys display, with the new chart
position. Press CLEAR to return to the initial display.
Using Home Mode
When you select the HOME option, the chartplotter centres the vessel and
changes to Home Mode. In this mode:
• The cursor is not displayed, but is fixed to the vessel’s position
• The cursor data box displays the vessel’s current position; if you are tracking
to a waypoint, it also displays the waypoint name, bearing and range
• In Head Up or Course Up modes (see Chapter 6), the display changes to
Relative Motion, in which the chart moves to keep the vessel in the centre of
the display.
• In North Up mode, the chart moves to ensure the vessel remains on-screen.
➤ To return to the standard cursor and motion mode, press the trackpad. The
cursor re-appears and the cursor data box displays the cursor position data.
Controlling
the Chart
To Next Page
Loading...
