Raymarine RayChart 630 - 5.3 The Current Route; Viewing the Current Route

Chapter 5: Using Stored Lists (EDIT) 53
The Current Route
5.3 The Current Route
The Current Route option allows you to view the currently selected route, with
progress details, and to specify a planned Speed Over the Ground (SOG) to
obtain an estimated time of arrival (ETA). You can also advance to the next leg
of the route from this screen.
Viewing the Current Route
➤ To view the Current Route information, select the CURRENT ROUTE option from
the EDIT menu.
The Current Route screen is displayed, as shown below.
D3815-2
CURSOR
50°36.68 N
009°47.60 E
COG SOG
208°M 1.4$
DEPTH IN FEET
100$
To Cursor
BRG
RNG
218°M 415.2$
NEXT LEG PLANNED SOG
SCROLL
DIGITS
CLEAR
CANCEL
ENTER
ACCEPT
SELECTION
CURRENT ROUTE 1
L/L
LEG BRG
ETA:
ELAPSE TIME:
TOTAL DISTANCE COV.:
0.0 Nm
LEG DIST.
01 006WPT
02 007WPT
03 008WPT
04 009WPT
44°03.70 N
179° 0.571
n
m
--:--
--:--
009°51.85 E
CURRENT SOG: 1.0 Kts
The Current Route screen lists the waypoints for the current route, showing the
waypoint symbol, sequence number in the route and name for each waypoint.
The box below the list gives the following details for the highlighted waypoint:
• Position, in either latitude and longitude or TDs, depending on your setup.
• Route leg bearing and distance (from waypoint to waypoint or, for the first
waypoint in a route, vessel to waypoint).
If the route is active, the following details are also provided:
• Estimated time of arrival (ETA) at the waypoint
• Total time elapsed since the start of the route
• Total distance covered since the start of the route
The ETA predictions are based on either the current or planned speed over the
ground (SOG), as displayed above the list of waypoints, depending on your
selection.