Raymarine RayChart 630 - 3.4 Measuring Distances Using the RULER Key

Chapter 3: Using the Initial Soft Keys 39
Measuring
Distances Using
the RULER Key
3.4 Measuring Distances Using the RULER Key
➤ You can obtain an accurate measurement of the distance between two points by
using the RULER soft key, as follows:
1. From the initial soft key display, press the RULER soft key.
The soft key labels change, as shown in the example below.
2. Use the trackpad to move the cursor to the measurement start point.
3. Press FROM. The start point is marked with an “F”.
4. Use the trackpad to move the cursor to the measurement end point. A
dotted line connects the From point to the cursor.
5. Press TO. The end point is marked with a “T”.
A dotted line connects the two points, and a ruler data box is displayed.
D3831-1
FROM
TO
EXIT
RULER
LAT/LON
42°51.37 N
42°51.37 N
FROM
TO
010°29.90 E
101°32.04 E
DST: 1.75
BRG: 090°M
6. If required, repeat with further FROM and TO positions. The ruler
information is updated each time you select a new FROM or TO location.
7. Press CLEAR or EXIT to clear the ruler display and return to the initial
screen.