42
RayChart 620 and 630
Marks and
Events
Placing and Deleting a Mark
➤ To place a mark symbol at the cursor position:
1. Press the MARK key.
The soft key labels change, as shown in the example on the following page.
The current mark symbol is shown below the cursor data box at the top left
of the screen.
2. If you wish to choose a different symbol for your new mark, press the
SELECT SYMBOL soft key. The Mark Symbols dialogue box is displayed in
the centre of the screen.
3. Use the trackpad to move around the symbols until the required symbol is
highlighted, and press ENTER.
The dialogue box is removed, and the new symbol is displayed under the
cursor data box.
D3829-1
MARK SYMBOLS
CLEAR
CANCEL
ENTER
ACCEPT
SELECTION
SELECT
SYMBOL
PLACE MARK
SELECT SYMBOL
DELETE MARK
EXIT
BRG
RNG
000°M 58.36$
4. Position the cursor at the point where you wish to place the mark.
5. Press the PLACE MARK soft key to place the new mark at the cursor position.
6. Press EXIT or CLEAR to return to the initial soft key display.
➤ To delete a mark:
1. Press the MARK key, to display the Mark soft key labels.
2. Position the cursor over the mark you wish to delete.
3. Press the DELETE MARK soft key to delete the mark.
4. Press EXIT or CLEAR to return to the initial soft key display.
To Next Page
Loading...
