Raymarine RayChart 630 - Editing the Waypoint Details; Clearing or Changing a GO TO

38
RayChart 620 and 630
Using the
GOTO Key
D3825-1
EDIT WAYPOINT
SCROLL
DIGITS
SELECT
CLEAR
CANCEL
ENTER
ACCEPT
SELECTION
NAME: ØØ1WPT
SYMBOL
LAT: 44°Ø4.39 N
LON: ØØ9°52.72 E
2. Use the left or right sides of the trackpad to move the cursor to the number,
letter or symbol you wish to change. You can hold the trackpad down to
move quickly.
3. Use the top or bottom of the trackpad to increase or decrease the number, or
change the letter or symbol.
4. Repeat steps 2 and 3 until the required information is displayed.
5. Press ENTER to save the details.
Clearing or Changing a GO TO
If a waypoint is already active when you request a GO TO, the chartplotter
displays the following message:
D3824-1
CLEAR
ENTER
MENU
WAYPOINT IS ALREADY ACTIVE
TO SWITCH OFF ACTIVE ROUTE
TO CANCEL
TO STOP TRACKING
The active waypoint may be a previous GO TO, or it may be the active waypoint
in the current route.
➤ To change to the new waypoint (GO TO target point), press ENTER.
➤ To cancel the GO TO and continue navigating to the existing active waypoint,
press
CLEARCLEAR
CLEARCLEAR
CLEAR.
➤ To stop navigating to the active waypoint, press MENU.
Note: This means you can abandon a GO TO at any time by pressing
GO TO
then
MENUMENU
MENUMENU
MENU . If you turned off the waypoint display when you set up your
chartplotter, the waypoint disappears since only the active waypoint and the
current route waypoints are displayed (see Chapter 6).