Raymarine RayChart 630 - Starting and Stopping a Track; Deleting the Current Track

44
RayChart 620 and 630
Using Track
Histories
Starting and Stopping a Track
➤ To start and stop a track:
1. From the initial soft key display, press the MENU key to display the main
menus.
D3360-2
SYSTEM
NAVIGATE
PLOTTER
ALARMS/TIMERS
FIX STATUS
MEMORY C-CARD
WAYPOINT LIST
CURRENT ROUTE
ROUTE LIST
FIND
LOG
CARTOGRAPHY
ORIENTATION
WINDOWS
COLOURS
START
EDIT
DELETE
TRACKS
SCREEN EDIT SET UP
2. Use the trackpad or press the TRACKS soft key to highlight the START option,
and press ENTER.
The option changes to STOP, indicating that Track History is turned on, and
the chartplotter starts laying down track marks.
The track data is stored in the track file that is set as the current track (see
below).
3. If you wish to turn Track History off again, highlight the STOP option and
press ENTER.
4. Press CLEAR to clear the menus.
Deleting the Current Track
Deleting a track clears all the track history data from the selected file, ready to
use it for new data.
➤ To delete the current track:
1. From the initial soft key display, press the MENU key to display the main
menus.
2. Use the trackpad or press the TRACKS soft key to highlight the DELETE
option, and press ENTER.
3. Press ENTER again to confirm the deletion.
The track data in the current track file is deleted.
If the track is currently active, the old data is cleared from the file and the
screen, but any new track history information is still stored in the current
file.
4. Press CLEAR to clear the menus.
Editing Track Controls
The EDIT option on the Tracks menu allows you to edit the controls for the
current track and also any other tracks stored in memory. You can: