Chapter 7: Installation 85
Installation
Chapter 7: Installation
7.1 Introduction
This chapter explains how to install the chartplotter. Installation should only be
undertaken by a competent installer.
The chartplotter can be trunnion (yoke) or panel mounted. It must be connected
to a power supply and to a source of position data (for example, a GPS), and can
also be connected to other units via the SeaTalk, Navaid or NMEA connections.
You can install more than one chartplotter as part of a larger system. Details of
the current route or GO TO are sent to the second unit.
An example of an integrated system is shown in the following diagram.
D3354-2
Extended Chartplotter System, using SeaTalk Connection Mode
GPS
Power
SeaTalk port 2
SeaTalk port 1
GPS Antenna
Chartplotter
Raydata
Raypilot 650
Raydata
Second Chartplotter
Distribution
panel
Speed
transducer
Depth
transducer
To Next Page
Loading...
