Chapter 5: Using Stored Lists (EDIT) 57
The Route
List
Route Details
➤ To display the details of the currently highlighted route:
1. Press the ROUTE DETAILS soft key. The Route Details screen is displayed.
D3817-2
CURSOR
50°36.68 N
009°47.60 E
COG SOG
208°M 1.4$
DEPTH IN FEET
100$
To Cursor
BRG
RNG
218°M 415.2$
SCROLL
DIGITS
CLEAR
CANCEL
ENTER
ACCEPT
SELECTION
ROUTE: ROUTE 00
L/L
BRG
SOURCE:
DATE:DATE:
DEPTH
TEMP.
RNG
01 001WPT
02 002WPT
03 003WPT
04 004WPT
05 005WPT
44°04.39 N
092° 0.712
n
m
CURSOR
01/01/70
TIME:
00:00:00
009°52.72 E
REVERSE SELECT
This displays the details of the waypoints in the route, in the same format as
the Waypoint List (see Section 5.2).
You can press the REVERSE soft key to reverse the order in which the
waypoints will be followed in the route, then press SELECT followed by the
FOLLOW soft key to start following the route. The soft key label is updated
to OFF.
2. Press CLEAR to return to the Route List, or ENTER to go to the Route Edit
screen (see below).
Editing a Route or Building a New Route
You can edit an existing route, or build a new route, simply by selecting existing
waypoints from the list.
➤ To edit an existing route or build a new route:
1. Display the Route Edit page, either:
- From the Route Details screen, by pressing ENTER, or
- From the Route List, by highlighting the required route and pressing
ENTER. Highlight an empty route if you wish to build a new route.
To Next Page
Loading...
